Original Banana Pi G1 Open Debugger Board Burner Module
Open Debugger is a set of programming tools in the development of STM series of microcontrollers, TI CC1x, 2x, TI CC3x series SOC, when STC Series MCU can be programmed quickly and easily debug, debugging programmer does not have to do something different series of chips switching plug tedious work.
In addition, it also integrates a USB to serial port, which is a common interface for embedded development.
It is also one of USB2.0 HUB, making it easy to extend to other USB tools.
With it, no longer need to face a bunch of different writer, complicated mess of wiring, USB port deficiencies.
Operating voltage: DC 5V
Operating temperature: 0°C to 85°C
The onboard voltage output: 3.3 V
Maximum output current: 2000 mA
Supported operating systems:
Microsoft Windows 2000
Windows XP SP2/SP3 operating system (32-bit versions)
Windows Vista operating system (32 and 64 bit)
Windows 7 operating system (32 and 64 bit)
Windows 8 operating system (32 and 64 bit)
a)CC Debugger Interface:
Programming and debugging of the following 8051-based TI SoCs:
CC2530, CC2531, CC2533
CC2543, CC2544, CC2545
Control the same apparatus to SmartRF Studio. In addition, you can also control the following transceiver SmartRF:
CC1120, CC1121, CC1125, CC1175
CC1100, CC1101, CC110L, CC113L, CC115L
It can also be used to program the PurePath wireless devices:
Programming and debugging mainstream ARM7 9 11, Cortex-A5 A8 A9 M0 M1 M3 M4
Supported MCU manufacturers:
ST, Freecale, Nuvoton, NXP, TI, Cypress, Atmel, Analog, Fujitsu, Toshiba, Energy Micro…
Speeds up the programming and debugging functions 4Mhz: Write Flash Rom, EEPROM, ARF, and support for full speed, stepping, breakpoints
JTAG programming and debugging interface for all supported kernel.
STC series microcontroller programming and debugging output port for printing information.
1 x Original Banana Pi G1 Open Debugger
|CSn||Chip Select (active low)|
|DUT||Device Under Test|
|LED||Light Emitting Diode|
|MISO||Master In Slave Out|
|MOSI||Master Out Slave In|
|SPI||Serial Peripheral Interface|
|USB||Universal Serial Bus|
|Target||Positive voltage on target|
|DIO||SWD DATA Input/Output|
|TMS||JTAG Test Mode Select|
|TCK||JTAG Test Clock Input|
|TDO||JTAG Test Data Output|
|TDI||JTAG Test Data Input|
|SRST||JTAG Test Reset Input, Active Low|
|RXD||USB Serial Input|
|TXD||USB Serial Output|
you can track your packages after an order has shipped.