RTF Mini "4-In-1" 12-AMP ESC HV 35×35 High Voltage Up To 4s
Users will need to install and wires. no extra cap needed.
Please note: This is for more advanced users.Good soldering is a must.
Watch your spacer size,the clearance is minimal.3mm spacers work best,but you still need to file down the thick edges.
All Nfets (bsnfet.hex)
12Amp constant with 15Amp burst (per channel)
Built in 5v-1A Linear BEC
3S-4S Capable (under 4S please make sure to keep good cooling)
Ultra light weight -14g with cap and signal wires. 18grams with all motors and power wires.
400hz and 490hz compatible – DJi, naze32, cc & MultiWii tested with mni motors to 25,000rpm
Size: 35mm (L) * 35mm (W) * 6mm (H)
uSEC range These are programmed to SimonK – idle ≤1064 – mid 1464 – high throttle ≥1864 uSec
Signal and motor cables are included.
Please Note: This is for advanced users.
This is not for the timid solderer; there are very small solder pads. Watch your spacer size, the clearance is minimal. 3mm spacers work best, but you still need to file down the thick edges. If you are not comfortable with a soldering iron, please see our B-12A esc.
SimonK firmware installed for best compatibility with high kv motors.
1× Mini "4-In-1" 12-AMP ESC
you can track your packages after an order has shipped.